Flyback design doubt

hello!

Is it possible to design flyback converter using toroid without air gap?

Thanks!

Hold on one moment,
your reply is being sent

Replies
bradtgr says:

Yes! It is possible, although better performance is easily obtained using smaller cores + small gaps, using air gap give lower inductance but more linear. Also using iron powder cores works, but they give higher losses due to the bulkier windings.

Despite all of this, if you only need very low power levels and you have ungapped cores it will work.

Published: 3 months ago
Do you want to simulate
the design?
UPGRADE YOUR ACCOUNT
This design is encrypted. You cannot see
the constructive parameters, but you can simulate the results for your waveform inputs.