How can I reduce skin losses

I'm trying to make a full bridge centre tapped transformer and my skin losses are really high, Im using a very thin round wire type (0.071mm) so this should reduce skin effects, but it makes my current density too high, How can I fix this?

Hold on one moment,
your reply is being sent

Replies

Try litz, if you are using a higher frequency or multiple parallel wires for lower ones, you can reduce the diameter of the strands and increase the count if you still get high losses.

Hope it helps :)

Published: 1 month ago
Edited by francescrom on 2 weeks before
Do you want to simulate
the design?
UPGRADE YOUR ACCOUNT
This design is encrypted. You cannot see
the constructive parameters, but you can simulate the results for your waveform inputs.