LLC converter design

Hi everyone!

I am designing a 3kW converter with 390Vdc at the input and 250-420Vdc at the output, is it better to use a full bridge LLC converter than a half bridge LLC converter? I ask this because the Q is lower for a given load when a full bridge LLC is used. Does that mean that the full bridge LLC can manage higher output voltage ranges?

Thank you!

Hold on one moment,
your reply is being sent

taliter says:

When using LLC this way it requires a wide frequency control range, i.e. 100k-400k Hz, or a high Q, as well, to obtain full power at low line and to reduce the voltage at no load and high line.

Published: 3 months ago
Do you want to simulate
the design?
This design is encrypted. You cannot see
the constructive parameters, but you can simulate the results for your waveform inputs.